Today I went on the hunt for old Kenworth trucks, and I found this oddity that I figured I would re-post it. There is no need for me to re-write history, so I'm just going to add the article below.
The theoretical advantage to gas turbines, besides their ability to swallow up a wide range of fuels, is their relative lightness and compactness compared to other internal combustion engines (gasoline, diesel) of the same output. Boeing decided to illustrate that advantage with this press photo we recently scrounged up, dated April 10, 1950, showing one of its 175hp gas turbines installed in a contemporary Kenworth conventional. The caption reads:
Gas Turbine and Diesel Truck Installations Show Vividly Simplicity of New Boeing EngineIdentical Kenworth Motor Truck Corporation units, powered by the new Boeing Airplane Company 175-horsepower gas turbine (left) and a diesel power plant of similar rating (right) are disclosed in this just-released photograph. The new Boeing gas turbine, which weighs only 200 pounds, has been undergoing road test near Seattle in the ten-ton truck for the past month. As installed experimentally, the Boeing turbine occupies only 13 percent of the space normally taken up by a conventional gasoline or diesel engine of equal power. The new engine operated on the same principle as the ship steam turbine and will burn kerosene, diesel oil or gasoline.
It’s no surprise Boeing chose to install the engine into a Kenworth: Both companies called the Seattle area home, and Kenworth was put to work building B-17s and B-29s during World War II. In his book on Kenworth history, Doug Siefkes noted that Boeing started to develop the engine to fulfill a Navy contract, and they subsequently suggested Kenworth give it a shot. The diesel, by comparison, weighed 2,700 pounds, so the turbine represented a significant weight savings.
To test it out, Kenworth sent the truck on a road trip from Canada to Mexico, then sent it on test runs from Seattle to Los Angeles, working with West Coast Fast Freight. According to Siefkes, the results were dismal:The Seattle-Los Angeles run was taking four or five hours longer than usual. The turbine-equuipped truck put out too much exhaust, had poor acceleration, and was tough on clutches. Fuel economy, or lack of it, was another problem: The truck traveled only 1 mile per gallon. The project was scrapped.Or, at least it was from the Kenworth side. Boeing continued to develop its gas-turbine engines over the next two decades and in 1961 even provided three 502-series gas-turbine engines to American-LaFrance for installation into its fire trucks.
Here are some other photos I found when searching for the Kenworth Boeing Turbine engine, these are 1952 KWs:
1 comment:
I love this story and I have a little more info on the early tests. The yellow Kenworth with the black stripe was the east/west pace truck only. It was used to go over the cascades and back. The truck was equipped with the biggest hp Cummins had at the moment. The north/south runs were looking at mileage and reliability. The east west were more like hard pulling time trials. I own the east/west truck and have paperwork from that time including some misc Boeing paperwork. The truck only has 6,300 miles but is in really bad shape due to the fact that it was sold to a mining company and sent to alaska. Mick Moss paid to have it brought back to Washington in the early 90’s. I’d give anything to see more pics and info on this trial. It’s a really cool part of trucking history and needs to be preserved. The original turbine truck is at the Deming log show grounds.
Post a Comment